球迷网

當前位置:首頁-新聞中心>>企業動態>>正確的儲存使用不干膠標簽的這些方法您知道嗎?

正確的儲存使用不干膠標簽的這些方法您知道嗎?

來源:http://tjanamera.com/ 日期:2021-04-22 發布人:admin 由于貴公司在采購不干膠標簽時,可能定的量多,做為庫存,時間久了就可能出現一點小問題,為了使您的不干膠標簽儲存時間久一點,我們要采取相對的措施,保持不干膠標簽良好的膠性。
As your company in the purchase of self-adhesive label, may be a lot of inventory, as a long time may appear a little problem, in order to make your self-adhesive label storage time longer, we need to take relative measures to maintain the good adhesive label.
下面是儲存不干膠標簽的條件和注意事項:
The following are the conditions and precautions for storing self-adhesive labels:
1、推薦倉庫儲存條件為:溫度為22-28℃,相對濕度為50%±5%。
1. The recommended storage conditions are: temperature 22-28 ℃, relative humidity 50% ± 5%。
每年4-11月期間為標簽存放期,在此時間內可作適量的倉存備品。冬季期間,一個月內的平均
The period from April to November every year is the best period for label storage, during which an appropriate amount of spare parts can be stored. During the winter, the monthly average
山東透明不干膠標簽印刷
溫度在5-12度或濕度低于50%時,不建議倉存時間超過30天;已使用貼上的標簽可抗溫度達-20度-125度。
When the temperature is 5-12 ℃ or the humidity is lower than 50%, it is not recommended to store for more than 30 days; The used label can resist temperature up to - 20 ℃ to - 125 ℃.
2、面材或標簽設有外包裝,在沒有倉庫溫濕控制設備的條件下,建議塑料薄膜密封包裝,每次使用后要再次密封包裝好,亦可為標簽提供較好的存放條件。
2. If there is no temperature and humidity control equipment in the warehouse, it is suggested that the plastic film should be sealed and packed again after each use, which can also provide better storage conditions for the label.
3、印好后的標簽包裝后要分層疊放,不可過重,防止膠水滲透粘連。
3. Printed labels should be stacked layer by layer after packaging, and should not be too heavy to prevent glue penetration and adhesion.
4、使用前防止日光直接照射。
4. Prevent direct sunlight before use.
5、被貼物表面要保持清潔;油污,水,灰塵顆料物都會影響標簽粘貼附著力下降,出現此情況必需用清水,酒精,干布對被貼物進行清潔后再貼上標簽。
5. Keep the surface clean; Oil, water, dust particles will affect the adhesive force of the label. In this case, it is necessary to use water, alcohol and dry cloth to clean the pasted object before labeling.
6、粘貼時,操作者的手指盡可能不要接觸膠水部份,或清潔雙手后小面積地接觸標簽一角,避免減弱標簽的粘貼力。
6. When pasting, the operator's fingers should not touch the glue part as much as possible, or touch the corner of the label in a small area after cleaning hands, so as to avoid weakening the adhesive force of the label.

上一篇:透明不干膠標簽廠家可定做
下一篇:最后一頁
聯系我們